For a solder or braze joint, the ____ depends on the amount of overlapping area of the base parts.
A. shear strength
B. ductility
C. fatigue resistance
D. corrosion resistance
Answer: A
You might also like to view...
Derating factors shall only be applied when the number of current-carrying conductors in a wireway exceeds _____.
a. 15 b. 20 c. 25 d. 30
Which of the following statements is LEAST-Likely true?
A. Some release bearings found on older European cars use a round carbon ring that slowly wears away with each use. B. An overcenter assist spring pulls the pedal toward the floor during the first half of travel and upward during the second half of travel. C. The clutch fork fits between the release bearing and the clutch cable or linkage. D. The release bearing hub has a provision to attach it to the clutch fork.
Petrobras, the Brazilian energy company, has identified two alternatives to provide potable water to offshore platforms—purchase and operate the equipment, or contract long term with Manal and Associates, an international oilfield service corporation. For the estimates shown, use capitalized cost analysis at i = 6% per year to determine (a) the better economic choice for Petrobras, and (b) the maximum annual M&O cost that will cause Manal and Associates to succeed in winning the contract.
 FIGURE 1.png)
Refer to Figure. Determine the rise
Fill in the blank(s) with the appropriate word(s).