wound rotor motor has been recently put back into service but is now rotating in the wrong direction. After examining the motor, you find that lead L1 is connected to T2, L2 to T3, and L3 to T1. To correct the rotation, you should
a. Connect L2 to T1, L3 to T2, and L1 to T3.
b. Connect L1 to T1, L2 to T3, and L3 to T2.
c. Connect L1 to T1, L2 to T2, and L3 to T3.
d. Reverse phase connections between the wound rotor and the resistor bank.
b. Connect L1 to T1, L2 to T3, and L3 to T2.
You might also like to view...
Describe the factors that significantly influence the location of highways in urban areas.
What will be an ideal response?
If the sides of a triangle are 14 inches, 10 inches, and 13 inches, what is the perimeter of the triangle?
What will be an ideal response?
How much effort is typically required to turn the steering wheel on vehicles with power steering?
A) 0.5-1.5 lbs. B) 2-3.5 lbs. C) 5-7 lbs. D) 10 lbs. or more
Which of the following statements is not correct?
A) Mechanical timing relays provide 0.05 to 180 seconds of on-delay and off-delay with an accuracy of +/- 10 percent. B) The instantaneous contact state change is the same as the waveform of the timed contacts. C) Some drift of the timer setting over time is typical. D) Pneumatics is used to develop the time delay by the controlled release of air.