Where is the suction line temperature read when adjusting a TEV?
A) At the inlet of the evaporator
B) As close as possible to the discharge service valve
C) As close as possible to the TEV bulb
D) At the inlet of the compressor
C
You might also like to view...
The difference in electrical charge between two points is referred to as ____.
a. current b. voltage c. amperes d. volts
If inspection reveals a loose fastener, you should _____.
a. report it to your supervisor b. remove it and install a new one c. install extra fasteners above and below the loose one d. tap it with a hammer to tighten it
Write your definition of revolution. Then use this definition to argue that the Civil War did or did not produce a revolution in the political, economic, and social life of the United States.
What will be an ideal response?
According to Ohm's Law, if voltage were to decrease while resistance remained the same, current would
A) decrease B) no way to determine C) increase D) remain the same