Milk bottles are sometimes annealed after blow molding. Why is this done?
What will be an ideal response?
To normalize the stresses that are induced by the molding process
You might also like to view...
Technician A says that SAI and included angle should be within 3 degrees from side to side for proper handling. Technician B that says the vehicle will pull to the side with the least SAI. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
What are the three methods by which a defrost cycle can be terminated?
What will be an ideal response?
Consider the duct system shown in the accompanying figure. Air flows through two 8- in.-by-10-in. ducts that merge into a 18-inch-by-14-inch duct. The average speed of the air in each of the 8 x 10 duct is 30 ft/s. What is the volume flow rate of air in the 18 × 14 duct? Express the volume flow rate in ft^3/s, ft^3/min, and m3/s. What is the average speed of air in the 18 ×14 duct?
Refer to the figure. Determine c-c length of L
Fill in the blank(s) with the appropriate word(s).