To forward bias a silicon diode ____________
A) The anode must be connected to a resistor (300-500 ohms) and 12.0 volts, with the cathode also connected to 12.0 volts
B) The voltage at the anode must exceed the voltage at the cathode by 0.3 to 0.5 volt
C) The voltage at the cathode must exceed the voltage at the anode by 0.3 to 0.5 volt
D) The voltage at the anode must exceed the voltage at the cathode by 0.5 to 0.7 volt
D
You might also like to view...
?Technician A says that steel shot blasting is commonly used to clean ferrous parts. Technician B says that steel shot blasting is commonly used to clean aluminum parts. Who is right?
A. ?Technician A only B. ?Technician B only C. ?Both A and B D. ?Neither A nor B
The RPM of a belt driven blower can be determined by:
A) Multiplying motor and fan sheave diameter and then divide by the motor RPM. B) Multiplying motor RPM and motor sheave diameter and then divide by the fan sheave diameter. C) Multiplying motor and fan sheave diameter and then dividing that total into the motor RPM. D) Multiplying motor RPM and fan sheave diameter and then divide by the motor sheave diameter.
When you are installing interior wood doors, it is important to remember that four hinges must be used when
the door height is greater than _____. a. 6-1/2 feet b. 7 feet c. 8 feet d. 9 feet
When the TO3 transistor is held with the leads facing you and down, the ____________________ is the left lead.
Fill in the blank(s) with the appropriate word(s).