?What has to be done to ensure that the weld has 100% penetration on thick plate or pipe?
A. ?The part must be preheated to above 350°F (175°C) before welding starts.
B. ?The welding machine needs to be set on its maximum amperage setting.
C. ?Make the molten weld pool as large as possible so it will melt all the way through.
D. ?The edges of the weld plate or pipe must have some type of groove made before welding.
Answer: D
You might also like to view...
Limit switches are momentary contact (spring returned), but not maintained contacts.
Answer the following statement true (T) or false (F)
The dimensions of keys and keyways are determined in relation to the diameter of the shafts with which they are used. , where D = shaft diameter, L = key length, and T = key thickness. What is the shaft diameter in inches that would be used with a key where L = 4.80 inches and T = 0.49 inches?
What will be an ideal response?
What is the maximum safe amount of refrigerant for a recovery cylinder with a water capacity of 50 lb, holding a refrigerant with a specific gravity of 0.9?
A) 50 lb × 0.9 = 45 lb B) 50 lb × 0.8 × 0.9 = 36 lb C) 50 lb × 0.8 = 40 lb D) 50 lb
Answer the following statement(s) true (T) or false (F)
1. Many autotransformer starters contain taps that can be set for 50, 65, or 80 percent of the line voltage. 2. Wound rotor type motors and synchronous motors generally use autotransformer starters. 3. Most autotransformer starters use two transformers to reduce the voltage applied to the motor during the period of acceleration 4. Autotransformer starters provide greater starting torque per ampere drawn from the line than any other type of reduced voltage starter. 5. For closed transition starting, four separate start contactors are used.