Which of the following statements refers to the feedback rule or signal flow?
A) The sealing instruction is an example of this type signal flow.
B) Test the midpoint block output between the brackets, depending on the test results one of the brackets moves to the middle.
C) If all convergent inputs are required to produce a valid output, then a valid output indicates that all input paths are fault-free.
D) Assume that brackets enclose the power supply that provides power to three other blocks in the diagram. If power is delivered to one of the system blocks, then the power supply is not the problem.
A
You might also like to view...
How much must be invested now to grow to $30 000 in seven years if the annual interest rate is 4.0 percent compounded
(a) annually, (b) semiannually, (c) monthly?
Bevels and V-grooves are best if they are cut after the parts are assembled.
Answer the following statement true (T) or false (F)
Using the formula V = 4/3 ?r 3, find the volume of a sphere with a radius of 3.25 feet.
a. 44 cu ft b. 76 cu ft c. 98 cu ft d. 143 cu ft
Which of the following statements is LEAST-Likely true?
A. A slow charge is easiest on the battery. B. During a slow charge, the charging rate is between 10 amps and 25 amps. C. A battery is fully charged at the end of a slow charge when its specific gravity does not climb higher during two checks with a hydrometer, done 1 hour apart. D. Following a recharge, if the difference between hydrometer readings taken from different cells is more than 0.050, the battery should be replaced.