When completing a topography plan, after drawing the balance of the contour lines, you should use the _____ option of the PEDIT command to provide a curve to each contour line.
A. Close
B. Join
C. Fit
D. Width
Answer: C
Trades & Technology
You might also like to view...
Explain the general purpose of a compound curve and a reverse curve.
What will be an ideal response?
Trades & Technology
Which diagnostic step is the most important aspect of diagnosis?
A) Verify the problem B) Visual inspection C) Retrieve the trouble codes D) Check the service bulletins
Trades & Technology
What is the purpose of the wedge shown in this drawing?
A) To increase spring capacity
B) To lower vehicle ride height
C) To raise vehicle ride height
D) To correct the driveshaft angle
Trades & Technology
The ozone layer primarily filters what type of radiation?
A) Ultraviolet B) Infrared C) Thermal D) None of these is correct
Trades & Technology