Explain how a switch loop for a single-pole switch following the requirements of Section 404.2(C) is wired. Assume the use of Type NM cable.
What will be an ideal response?
Two-wire cable feed to lighting outlet box.
Three-wire cable installed from lighting outlet box to switch box.
White wire of three-wire switch loop cable connected to white grounded wire of feed cable and lighting fixture grounded wire in outlet box with a wirenut.
Black wire of three-wire switch loop cable connected to black wire of feed cable in outlet box with a wirenut.
White wire in three-wire switch loop cable capped off with a wirenut in switch box for possible future use.
Black wire of three-wire switch loop cable connected to one of the switch terminal screws.
Red wire of three-wire switch loop cable connected to other terminal of the switch.
Red wire of three-wire switch loop cable connected to ungrounded screw or pigtail of the light fixture in the out let box.
You might also like to view...
How is the capacity of a screw compressor controlled?
What will be an ideal response?
At least one wall switch-controlled lighting outlet is required to provide illumination on the ____.
A. exterior side of an outside entrance or exit with grade-level access B. interior side of an outside entrance or exit with grade-level access C. adjacent to a vehicle garage door D. adjacent to exterior stairs
In what application are vacuum tubes still found in electronic communications?
A. Frequency-modulated oscillator B. High-power radio transmitters C. Stereo multiplex FM broadcasts D. Frequency-division multiplexing
What is the name of the transmission design which uses two hydraulic clutches, two bands, two planetary gearsets, an overrunning clutch, and a valve body?
What will be an ideal response?