When showing a blind drilled hole (a hole ending within the feature), it is customary to show the slant at the end of the hole at 45°
Indicate whether the statement is true or false
False
Trades & Technology
You might also like to view...
What system can be said to provide the most effective means for controlling emissions?
A. Engine management computer. B. Fuel injection systems. C. Ignition timing systems. D. Cooling and lubrication.
Trades & Technology
If the needle of an ohmmeter used to check a capacitor goes toward the 0 ohms reading, stops and falls back to 20,000 ohms, what does this mean?
What will be an ideal response?
Trades & Technology
What is usually installed into the Ni-Resist insert of a piston assembly?
A. upper compression ring B. wrist pin C. piston skirt D. oil control ring
Trades & Technology
No information to the left of a groove weld symbol indicates ________ required
A) Partial penetration B) No penetration C) Complete joint penetration D) None of the above
Trades & Technology