Determine the location of the 40-kN load such that sags at points B and C in Figure P6.14 are 3 m and 2 m, respectively. Determine the maximum tension in the cable and the reactions at supports A and D.




Trades & Technology

You might also like to view...

To determine the takeout of a 45-degree elbow, multiply the nominal size of the elbow by ____.

a. 1/2 b. 5/8 c. 1 d. 1-1/2

Trades & Technology

Technician A says that in chassis wiring that observes the new SAE wiring standards, any white wire with an orange tracer indicates a protected circuit. Technician B says that over 100 different colors identify different wires used in the new SAE wiring standards. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

The federal agency regulating stormwater discharge on construction sites is the _____

a. National Institutes of Health b. Occupational Safety and Health Administration c. Environmental Protection Agency d. National Oceanic and Atmospheric Administration

Trades & Technology

Technician A states that when diesel fuel is combusted, one of the products of combustion is water. Technician B states that carbon dioxide results from burning diesel fuel. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology