Which of the following statements is accurate?

An ammonia synthesis process works as follows: Fresh feed air and hydrogen are combined with a recycle stream and the combined stream is compressed to 10 MPa. The compressed stream enters a reactor, and a fraction of the entering nitrogen and hydrogen are converted into ammonia. The reactor effluent, still at 10 MPa, enters a condenser. The liquid and vapor streams leaving the condenser are in VLE. The liquid stream, which is almost pure ammonia, is the product. A fraction of the vapor stream leaving the condenser is purged, while the rest is recycled.


A. Raoult’s Law would be a reasonable way to model the VLE for ammonia in the condenser.
B. Henry’s Law would be a reasonable way to model the VLE for oxygen in the condenser.
C. If we increase the size of the reactor, allowing a larger fraction of the nitrogen and hydrogen to be converted to ammonia, it won’t lead to an increase in the liquid product flow rate, because the product flow rate is limited by the equilibrium constraint in the condenser.
D. If we maintain the same flow rate of entering feeds, but we purge a smaller fraction of the vapor leaving the condenser, then the mole fraction of oxygen in the purge stream will go down.
E. None of the above are true.

Trades & Technology

You might also like to view...

Are improving irrigation efficiency and practicing minimum leaching good practices to help reduce

saline discharges from fields?

Indicate by YES (Y) or NO (N).

Trades & Technology

Are valves in a one-pipe system used for throttling steam to the unit? Why or why not?

What will be an ideal response?

Trades & Technology

What are the four types of bevel gears commonly used in industry?

What will be an ideal response?

Trades & Technology

To determine the correct fastener and spacing for framing a floor system or any other part of the structure you must use ________

A) IRC Table R602.3(1 ) Fastening Schedule B) Engineered Wood Association's Fastener Recommendation Chart C) AWPA Guideline for Subfloor Fastening D) Common sense

Trades & Technology