What process takes place in the leaves of plants?

A) erosion control
B) silage
C) photosynthesis
D) storage


C

Trades & Technology

You might also like to view...

Technician A says an injector balance tester may be used to test the injectors in a port fuel injected engine for proper operation. Technician B says an injector balance tester may be used to analyze the signals to the injectors on a port fuel injected engine from the computer. Who is correct?

A. Technician A B. Technician B C. Both A and B D. Neither A nor B

Trades & Technology

The thicker the pipe wall, the greater the ____ the pipe can carry.

A. volume B. pressure C. area D. flow rate

Trades & Technology

Which weld is the first weld to be made as required by the welding symbol shown in Figure 4?

a. Fillet
b. Bevel groove

Trades & Technology

Which of the following is true?

A. The equation “dH = MCPdT” can be used to find the change in enthalpy when liquid boils into vapor, as long as the boiling occurs at constant pressure. B. All compounds have the same normal boiling point, since the normal boiling point is always defined at P = 101.325 kPa. C. If you compress a gas isothermally, it will condense into a liquid. D. The heat capacity of a substance in the liquid phase need not be the same as the heat capacity of that same substance in the vapor phase. E. None of the above are true.

Trades & Technology