A gateway and router in an Ethernet TCP/IP network differ in that ________
A) there is no difference
B) a gateway is a network point that provides access to another network
C) a gateway directs data packets to the correct destination based on the IP address
D) None of the above
B
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. A heat pump provides both heating and air conditioning within the same unit. 2. The two-stage thermostat is a thermostat that contains one mercury contact and one zinc contact. 3. The sequence timer is an on-delay timer used to connect the heating elements to the line all at once. 4. The terminal board shows terminal connections marked inside hexagon-shaped figures. 5. Terminal identification is used to simplify a schematic diagram.
In a right triangle, a and b represent legs and c represents the hypotenuse. Determine the measure of side b if a = 25.5 m and c = 32.5 m. Express the answer to the nearest tenth meter.
Fill in the blank(s) with the appropriate word(s).
When an offset section is used, ____.
A. the section shows dark vertical lines where the cutting plane lines changed direction at 90° B. hidden lines and centerlines are usually ignored C. the cutting plane line normally extends completely through the object to clearly display the location of the section D. the cutting plane line is drawn completely through the object usually along a center plane E. none of the above
A DCT transmission is really two separate transmissions, one for the even-numbered gears and one for the odd-numbered gears.
Answer the following statement true (T) or false (F)