The last step after replacing a defective CV boot is to ________
A) Separate the CV joint before installation
B) "Burp" the boot
C) Lubricate the CV joint with chassis grease
D) Mark the location of the boot on the drive axle shaft
B
You might also like to view...
The most common coil symbol used in schematic diagrams is the ____________________.
Fill in the blank(s) with the appropriate word(s).
Which of the following statements about mixture critical points is true?
A. Just like pure components, a binary mixture will possess only one critical point for the system. B. The critical temperature of a binary mixture is just the mole fraction of the components in a mixture multiplied by their pure-component critical temperature. C. For a binary mixture, there is not one critical point but a locus of critical points, which depend upon the system temperature or pressure (according to the Gibbs phase rule). D. All of the above are true. E. None of the above are true.
Describe the practice for representing a sheet metal part is with only the formed sheet metal part model and flat pattern.
What will be an ideal response?
An automobile repair shop owner has a plant with equipment valued at $335,000.00. If the tax rate in the community is 35 mills, what is the tax bill?
A. $10,725 B. $11,725 C. $12,725 D. $13,725