The last step after replacing a defective CV boot is to ________
A) Lubricate the CV joint with chassis grease
B) Separate the CV joint before installation
C) "Burp" the boot
D) Mark the location of the boot on the drive axle shaft
C
You might also like to view...
What is the function of the power supply?
What will be an ideal response?
What mixture concentricity of propylene glycol to water provides maximum antifreeze protection?
A. 100 percent B. 60 percent C. 30 percent D. 20 percent
Technician A says that a PAX run-flat tire uses a special wheel. Technician B says that a standard tire can be used to replace a PAX run-flat tire. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
ACR tubing is cleaned, degreased, dehydrated, and sealed to keep its:
A) Insides clean. B) Bright shine. C) Nitrogen base high. D) Aesthetic appeal.