You are working in a drawing with units set to architectural, but when you begin dimensioning, AutoCAD provides four-place decimal units. What is the problem? What do you need to do so that your dimensioning units match your drawing units?

What will be an ideal response?


Dimensions have their own style, including unit type. To specify architectural dimensions, you must create a dimension style with this type of dimension.

Trades & Technology

You might also like to view...

Which pH value is an indicator of a strong acid?

A) 0 B) 7 C) 14 D) 100

Trades & Technology

Which of the following is LEAST-Likely a component of a hand-held grease gun?

A. Spring-loaded piston B. Lubricating cartridge C. Nozzle D. Cylinder

Trades & Technology

Identify the items that should be included in a preliminary gas furnace safety check. You may select more than one item

A) condensation and rust on vent B) ohm out blower motor windings C) no flammable liquids stored near furnace D) gas content analysis E) check TEV bulb installation F) proper combustion air G) check for gas leaks

Trades & Technology

In residential construction, posts and beams are usually spaced at _____ o.c.

A. 36" (900 mm) B. 48" (1200 mm) C. 52" (1300 mm) D. 60" (1500 mm)

Trades & Technology