Where angularity is intended to apply to the high points of the surface only, the ____________________ plane modifier is specified in the tolerance portion of the feature control frame.
Fill in the blank(s) with the appropriate word(s).
ANS: tangent
You might also like to view...
A(n) ____________________ joint is made by overlapping the edges of two plates, and can be welded on one side or both sides with a fillet weld.
Fill in the blank(s) with the appropriate word(s).
Chelated micronutrients cost much more than the standard micronutrient salts. Wha t condition in the root substrate justifies the use of chelated micronutrients?
What will be an ideal response?
Large water pump pliers can be used:
A) For any bolt and nut it will extend to fit B) For unfinished packing nuts, pipe and pipe fittings C) To loosen arbor nuts D) All of the above
Refer to Figure P3.44 and use the principle of superposition to determine the current i through R4 due to the current source IS .
