Answer the following statement(s) true (T) or false (F)
1. Almost all industrial applications for SCRs require full-wave rectification of the AC voltage.
2. The phase-shift network can be the same as for a single SCR.
3. In the accompanying figure, two SCRs have been connected so that their cathodes are tied together to form the negative post of the bridge rectifier.
4. In the accompanying figure, since each half of the AC waveform must pass through one of the SCRs, only two are needed for full control of the bridge rectifier.
1. True
2. True
3. False
4. True
You might also like to view...
Technician A says that vehicles capable of using 100% ethanol are known as flex fuel vehicles. Technician B says that these vehicles are unable to achieve 100 horsepower. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
A rain-sense wiper system uses a rain sensor that is usually mounted ________
A) Inside of the windshield at the top B) On the roof C) Outside of the windshield at the top D) Behind the grille
When a one-piece, parallel-joint driveline arrangement with 2 universal joints is used, which of its angles must be equal and opposite?
A. working angles of its two U- joints B. angles of both mating yokes C. angle of the transmission output shaft and the axle pinion shaft D. all of the above
An air impact wrench not be used to remove or install the FWD drive axle shaft nut
Indicate whether the statement is true or false