The ____ is a form showing a number of bar diagrams with letters substituted for dimensions.
A. reinforcing bar schedule
B. rebar schedule
C. coded bar schedule
D. orthogonal schedule
Answer: A
You might also like to view...
The difference between measurements taken on the same axis (top to bottom) is known as ____.
a. cylinder diameter b. cylinder height c. cylinder taper d. cylinder draught
To forward bias a silicon diode ________
A) The voltage at the anode must exceed the voltage at the cathode by 0.3 to 0.5 volt B) The anode must be connected to a resistor (300-500 ohms) and 12.0 volts, with the cathode also connected to 12.0 volts C) The voltage at the cathode must exceed the voltage at the anode by 0.3 to 0.5 volt D) The voltage at the anode must exceed the voltage at the cathode by 0.5 to 0.7 volt
Technician A says that the cylinders should be bored and/or honed to match the size of the pistons to be used. Technician B says that bolt holes should be chamfered and cleaned with a thread chaser before assembly. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Which IEEE standard supports QoS and enables prioritization of frames in DCF?
A. 802.11f B. 802.11e C. 802.11d D. 802.11c