A fillet weld should be built up to be ____ the thickness of the plate.
A. equal to
B. half the thickness of
C. slightly thicker than
D. much thicker than
Answer: A
You might also like to view...
In order to prime a typical fuel sub-system with a hand-primer pump that has to be installed into the circuit, where should it ideally be located?
A. close to the pick-up tube B. upstream from the primary filter C. upstream from the transfer pump D. downstream from the secondary filter
What is one major advantage of bimetallic overload relays?
a. There is no automatic reset feature. b. They can be adjusted to trip within a range of 85% to 115% of the nominal trip rating of the heater unit. c. They consistently trip. d. They can be manually operated
List the three factors that limit the amount of inrush current in the primary transformer.
What will be an ideal response?
One major advantage of using a masonry saw is the reduced amount of dust caused by the dry sawing process.
Answer the following statement true (T) or false (F)