A front-wheel-drive vehicle has a clicking noise in the front of the vehicle when cornering below 20 mph. The front end of the vehicle is lifted and supported on safety stands. With the right front lower control arm lifted with a floor jack, the clicking noise is heard, but with both front wheels dropped downward, the noise disappears. Technician A says the right-front outer drive axle joint is worn. Technician B says a worn inner drive axle joint could cause a vibration during acceleration. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: C
Trades & Technology
You might also like to view...
Heater elements on electric pool-water heaters must be subdivided into loads not exceeding 48A each and be protected by overcurrent protective devices not greater than _____.
a. 50A b. 60A c. 75A d. 100A
Trades & Technology
The two types of load calculations outlined in Manual J8 are:
A) Square footage factor procedure and air change factor procedure. B) Residential load procedure and commercial load procedure. C) Peak load procedure and average load procedure. D) Daily load procedure and seasonal load procedure.
Trades & Technology
The most widely used cellular standard in North America today is:
A) FDM B) AMPS C) TDMA D) CDMA
Trades & Technology
Convert decimal 64 to binary
A) 01001000 B) 01010010 C) 00110110 D) 01000000
Trades & Technology