How are spot and seam welds similar?
What will be an ideal response?
They are both made by either the resistance type process or by a process with enough arc energy to penetrate through one member down through the faying surfaces into another member. Producing overlapping spot welds can make a seam weld.
You might also like to view...
In regards to limits on recovery, what are the four primary factors that must be met or proven for a claimant to receive compensation?
What will be an ideal response?
The heat input to the diesel cycle is nearest:
The pressure and temperature at the inlet to an ideal diesel cycle, with P-v diagram shown, are 100 kPa and 10ºC. It has a compression ratio of 18 and a cut-off ratio of 2. The maximum temperature in the cycle is 1400ºC. Assume constant
specific heats from Table below for all calculations.
A) 775 kJ/kg
B) 800 kJ/kg
C) 825 kJ/kg
D) 850 kJ/kg
Which term describes the process of adjusting variables such as speed, load, and spark timing to determine the optimum output settings for the computer?
A) Engine mapping B) Signal conditioning C) Reflashing D) Performance programming
A three-state buffer is a device that
A) can supply more output current than standard TTL circuits. B) has HIGH, LOW, and floating output levels. C) can be connected with other similar devices to a data bus. D) can do all of these things.