Excessive negative camber will cause which of the following?
A) Inner tire wear B) Improper handling
C) Excessive wheel bearing loading D) All of these are correct.
D
You might also like to view...
Overloads can be divided into two basic groups. What are these?
What will be an ideal response?
A company that carefully evaluates job applicants is using
a. concurrent control. b. steering control. c. postaction control. d. cybernetic control. e. yes-no control.
What is the normal allowable source voltage deviation from the motor's nameplate voltage rating?
A) The source voltage can be any voltage equal to or less than the motor nameplate voltage. B) A deviation of 10 volts is normally allowable. C) A deviation of 10% of the nameplate rating is allowable. D) No deviation is allowed. The voltage must be exactly what the nameplate calls for.
When using the TMC recommended practice (RP 618A) method of setting bearing endplay on commercial truck wheel ends, what is the first step torque setting usually specified as?
A. 50 lb-ft (68 N.m) B. 200 lb-ft (270 N.m) C. 400 lb-ft (540 N.m) D. 600 lb-ft (810 N.m)