If a wire repair, such as that made under the hood or under the vehicle, is exposed to the elements, which type of repair should be used?
A) Wire nuts and electrical tape
B) Solder and adhesive-lined heat shrink or crimp-and-seal connectors
C) Butt connectors
D) Rosin-core solder and electrical tape
B) Solder and adhesive-lined heat shrink or crimp-and-seal connectors
You might also like to view...
Faced fiberglass board insulation is limited to service temperatures of less than _____.
a. 1,000°F (540°C) b. 850°F (450°C) c. 450°F (232°C) d. 150°F (66°C)
Technician A says to reduce the chance of slipping under heavy load, increasing the pressure will hold the planetary control units tightly. Technician B says a throttle cable or electronics are used to sense engine load in a transmission or transaxle not equipped with a vacuum modulator. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
While having a discussion, Technician A says that the majority of ABS problems result from failure of a wheel speed sensor. Technician B says that some wheel speed sensors fail because of exposure to harsh operating conditions, and others fail due to abuse. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Where should the evaporative cooling system be installed?
What will be an ideal response?