Process control charts:

a. show how material are moved to and from work locations.
b. indicate inspection locations.
c. indicates the time needed for each function.
d. All of these are correct.
e. None of these are correct.


D

Trades & Technology

You might also like to view...

For cleaning ACR copper tubing before soldering, a material that can be used is ____.

A. steel wool B. carborundum cloth C. sand cloth D. nylon wool

Trades & Technology

Technician A says the RO is a legal document between the shop and the customer. Technician B says the RO should be well written, clean, and legible. Who is correct?

A. Technician A B. Technician B C. Both A and B D. Neither A nor B

Trades & Technology

The number of basic grades in which Plyform sheets for form building are available is _____

a. two b. three c. four d. five

Trades & Technology

In the above figure, suppose the physical load driven by the motor is reduced. As the motor speeds up, the CEMF ____________________ (increases, decreases), the net voltage across the armature ____________________ (increases, decreases), and the voltage at the junction between R8 and R9 ____________________ (increases, decreases). It is amplified by op amp 1, causing the summing amp to produce a voltage that is ____________________ (less, greater) negative turns Q1 on ____________________ (less, harder), and causes the SCR to fire ____________________ (sooner, later), which ____________________ (increases, decreases) the motor speed back to its desired

rpm. Fill in the blank(s) with the appropriate word(s).

Trades & Technology