While having a discussion, Technician A says that when blow-drying a bearing, you must allow it to spin. Technician B says that allowing it to spin is a bad idea. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: B
You might also like to view...
____________________ dimensioning usually yields the largest accumulation of tolerance between features.
Fill in the blank(s) with the appropriate word(s).
Most transient suppression modules consist of an RC circuit that is designed to suppress coil voltage transients to approximately what percentage of the peak coil supply voltage?
a. 125% b. 200% c. 250% d. 300%
How did the Investiture Controversy transform the papacy?
a. It became a political player in Europe. b. It became much weaker than it had been before the conflict. c. It assumed direct control of the Holy Roman Empire. d. It withdrew entirely into the spiritual realm and abandoned politics.
The bar system of pressure measurement is used primarily:
A) In the United States. B) By countries on the SI system. C) In third world countries where regular pressure gauges are too costly. D) In countries with a high per capita consumption of alcoholic beverages.