____ is the true measurement of a part after it had been produced.

A. Nominal Size
B. Designed Size
C. Clearance Size
D. Actual Size


Answer: D

Trades & Technology

You might also like to view...

If footings are not placed below the frost line in a cold climate, freezing of the ground can cause the foundation wall to _____.

a. crack b. sink c. crumble d. lean inward

Trades & Technology

When testing an ECT sensor on a vehicle, a digital multimeter can be used and the signal wire back probed. What setting should the technician use to test the sensor?

A) Amperes B) DC volts C) Ohms D) AC volts

Trades & Technology

Secondary loop fluid Potassium Formate is compatible with which piping materials?

What will be an ideal response?

Trades & Technology

Which of the following is correct for a gated D latch?

A) The output toggles if one of the inputs is held high. B) The output complement follows the input when enabled. C) Q output follows the input D when the ENABLE is high. D) Only one of the inputs can be high at a time.

Trades & Technology