A tooling designer is designing a jig that will insert pins into the flip-up handles of a coffeemaker. The bin to hold the pins should hold enough pins for 3 h of work before reloading. The engineering estimate for the rate of inserting the pins is 300/h. The pin diameter is 0.125 in. Because of space constraints, the bin must be designed as shown in Figure 4.17. The bin can be only the width of one pin. What is the minimum height that the bin should be if there is 0.250 in. at the top when it has been filled with the required number of pins?
Trades & Technology
You might also like to view...
As a substitute for the wage-incentive system, slaveowners most often used the
A. promise of eventual freedom. B. reward of some legal rights. C. the promise to slaves of a grant of private property to do tenant farming after a period of years of bondage. D. whip as a motivator. E. threat of death.
Trades & Technology
In question #20 what would be the answer if the wire size is #12, the voltage is 120 V, and the amperage is 15 amps?
What will be an ideal response?
Trades & Technology
A comment in Verilog is preceded by ________
A) ; (a semicolon) B) -- (a double dash) C) \\ (two backward slashes) D) // (two forward slashes)
Trades & Technology
Vehicles that run on pure ____________________ are true zero-emission vehicles.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology