When you are installing a prehung door, what should be done with the factory-installed spacer shims between the door and the frame?
a. Leave them in place permanently.
b. Remove them after the door is attached to the rough opening.
c. Remove them before you start the installation.
d. Remove them when the door is in place, but before you attach it to the rough opening.
Answer: B
You might also like to view...
What type of couplings are used in applications where only small amounts of misalignment can be tolerated without damage to equipment or decreased performance?
A. Rigid B. Fluid C. Flexible D. Rotating
A Mechatronic Supervisory control system requires:
a. A digital computer monitoring the system performance b. Individual controllers actually controlling each of the processes c. The controllers get the set point from the computer d. All of the above e. A supervisor in the loop
The Greek letter omega (?) represents what unit of electricity?
A) Volt B) Ohm C) Ampere D) Coulomb
Technician A says that a neutral safety switch is designed to open circuit when a transmission is in Park range. Technician B says that a neutral safety switch is designed to close when the transmission is in neutral. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B