Determine the amount of flooring required for the Real Estate Office in Appendix E. Using the labor rates from Problem 7-31 and the crew rate for the finish crew from Problem 7-32 determine the cost install the flooring.
What will be an ideal response?
Run the carpet top to bottom. Order the following pieces of carpet:
Order 291 lineal feet by 12 foot wide, or 388 square yards. Run the carpet left to right. Order the following pieces of carpet:
Order 299 lineal feet by 12 foot wide, or 399 square yards. This layout has fewer seams.
The following data can be extracted from the model for the rubber base:
The gross length of the rubber base is 1019?. From that we must subtract the doors. The following data can be extracted from the model for the doors:
Three of the interior doors are for the men’s room, janitor’s closet, and the women’s room and will only have rubber base on one side. The exterior doors only have rubber base on one side.
Doors = 1 ea × 3? + 17 ea × 2 sides × 3? + 3 ea × 3? + 1 ea × 6? = 120?
Base = 1,019? – 120? = 999?
You might also like to view...
The initial zone structure for regional travel demand model has been proposed as summarized below. Name three potential problems with this structure.
Zones: 50 Employment: 100,000 Labor Force: 60,000 Population: 200,000 Trips produced by the study area: 100,000 Trips attracted by the study area: 150,000 What will be an ideal response?
A crop whose vegetative parts—including stems, leaves, and sometimes seed or grain—are used for livestock feed is called a ____________________ crop
Fill in the blank(s) with correct word
All SAE fittings used in brake systems have a 45-degree taper on the male nut and on the inside of the flare.
Answer the following statement true (T) or false (F)
If the heater in a fixed IEC bimetallic overload relay fails, _____
A) it and all the other heaters in the overload relay must be replaced B) the heater can be replaced with a heater of the same size or one that is slightly smaller C) the heater must be replaced with a heater of the same size D) the entire overload relay must be replaced