When using a weave bead on vertical V-groove welds, _____
a. pause slightly at each toe to prevent undercut
b. do not chip and clean the weld between passes
c. change to an AC welding current
d. the width of the bead should be at least 5 times the electrode diameter
a
You might also like to view...
Look at your favorite web site and find what is meant by “web-in-the-sky”?
What will be an ideal response?
Determine dimension c in the accompanying figure to two decimal places. All dimensions are in inches.
A. 5.52 in B. 5.54 in C. 5.56 in D. 5.58 in
What is meant by the coil split?
A) The part of an A-coil evaporator where the two halves are joined B) An opening at the seam in the copper tubing C) The dividing point in an evaporator between high-side pressure and low-side pressure D) The temperature difference between the coil operating temperature and the air passing over the coil
Suppose that a logic gate has 3 inputs. How many possible input combinations must be listed in its accompanying truth table?
A) 1610 B) 810 C) 210 D) 410