The asynchronous inputs to a flip-flop are normally labeled ________ and ________, and are normally active ________ inputs
A) START, STOP, low B) ON, OFF, high
C) SET, RESET, high D) PRE, CLR, low
D
You might also like to view...
A laboratory reports the following vapor-pressure data for a particular organic chemical:
What will be an ideal response?
Technician A says that a drill is usually needed to remove a rivet. Technician B says that the most common rivet is a pop rivet. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Name one method of reducing stray capacitance on printed circuit boards
A) use swamping resistors when possible B) always use the same value capacitors C) capacitors should have short lead length D) all of the above
Which of the following is not part of comprehensive component monitoring?
A. Open circuits B. Short circuits C. Catalyst efficiency D. Sensor rationality