At what point should a tire be deflated when it going to be replaced?

A. before removing it from the truck wheel
B. immediately after removing it from the wheel
C. just before removing a split rim
D. just before breaking the bead


Answer: A

Trades & Technology

You might also like to view...

Which of the following is a monitoring and maintenance activity that should be performed by process technicians on electrical motors?

A) Measure the amps at the motor B) Lubricate the bearings when scheduled or noisy C) Ensure oil wells have water D) Inspect vapor passages to make sure they are not plugged

Trades & Technology

In a Common-Emitter amplifier

A) the emitter is the reference for the input signal B) the emitter is always above ground potential C) the output is taken from the collector D) the output signal is taken from the emitter

Trades & Technology

In a cycle counting system, "A" items are usually:

I. expensive items. II. items which often experience imbalances. III. difficult to get items. A) I and II only B) I only C) III only D) I and III only E) I, II and III

Trades & Technology

Find the Thévenin equivalent network seen by the load R0 in Figure P3.58, where R1 = 10?, R2 = 20?, Rg = 0.1?, and Rp = 1?.

Trades & Technology