Technician A says that many vehicles use lower control arms with non-removable ball joints. Technician B says that heat should be used to bend a deformed suspension component within specifications. Which technician is correct?

A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B


A

Trades & Technology

You might also like to view...

Grain sorghum is produced primarily in which two states?

a. Illinois and Michigan c. North and South Dakota b. California and Washington d. Kansas and Texas

Trades & Technology

The ____________________ capacitor has two metal plates with an air dielectric.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

A vehicle's reverse lights are always on, even in "drive." What is the most likely cause?

a. A misadjusted neutral safety switch b. An open neutral safety switch c. One of the reverse light bulbs has been installed backward d. The wrong bulb was installed for the reverse lights

Trades & Technology

ASE-Style Multiple Choice ____ occurs when plastic deformation has caused the metal to become very hard in the bent area.

A. Direct damage B. Indirect damage C. Work hardening D. Deformation

Trades & Technology