G90 G20 F10 X2.5 will command the machine to move parallel to the x-axis, to a point:
A. that is 2.5 inches from the current location, at a feed rate of 10 in/min
B. that is 10 inches from the current location, at a feed rate of 2.5 in/min
C. where x = 2.5 inches, at a feed rate of 10 in/min
D. where x = 2.5 inches, at a rapid feed rate
Answer: C
You might also like to view...
Using a ________ when turning a drum prevents tool chatter
A) Reverse thread B) High speed C) Soft tool bit D) Silencer band
All batteries should be in a secure bracket that is bolted to the vehicle to prevent physical damage to the battery
A) True B) False
What is a common location for a post indicator valve?
a. next to the water meter b. on an exterior wall c. on the main system riser d. in a utility or mechanical room
A wheel speed sensor is producing lower than expected voltage as the wheel rotates. Which of these is NOT a possible cause?
A) Incorrect air gap between the sensor and toothed ring B) Damaged or corroded electrical connector C) Debris on the sensor D) All of these are possible causes