Which manufacturer-supplied reference uses pass/fail tests to guide the technician to the possible cause of system malfunction?
A) The logic flowchart B) The symptoms list
C) The benchmark data D) The fault code reference list
A
You might also like to view...
Two 90-degree outside bends are needed to prepare a square-welded, two-piece, 0.35 cm steel-plate machinery cover. The square pipe has an O/S wall measurement of 65.5 cm. Find, in centimeters, the length of each piece used for the weldment.
What will be an ideal response?
Power cycles typically have an efficiency well below the efficiency of a Carnot cycle. Which of the following is most responsible for this?
A) Friction B) Heat transfer across a finite temperature difference C) Heat transfer from pipes connecting the various components D) Pressure drops in pipes
Technician a says that the red brake warning light can be turned on if a difference in pressure is detected by the pressure differential switch. Technician B says that the red brake warning light can be turned on if the brake fluid level sensor detected low brake fluid level. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
All of the following statements concerning the use of an electrical schematic are true EXCEPT:
A. An electrical schematic can aid a technician in understanding how a system is designed to operate. B. An electrical schematic is designed to be used only by automotive engineers and should never be used by an automotive field technician. C. An electrical schematic can show circuit components, powers, grounds, computer input circuits, computer output circuits, and multiplexing data busses. D. An electrical schematic can be used with a flow chart to maximize the technician's diagnostic potential.