Feedback signals are used to confirm position and operation of an actuator.

Answer the following statement true (T) or false (F)


True

Trades & Technology

You might also like to view...

A P0108 DTC is being discussed. Technician A says a MAP sensor O-ring damaged or missing could be the cause. Technician B says the MAP sensor signal circuit shorted-to-ground could be the cause. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

A TEV with a dead power element will operate:

A) Correctly until an adjustment is made to the valve. B) With a higher than normal evaporator pressure. C) With a high superheat. D) With a low superheat.

Trades & Technology

Technician A says the bare metal should be cleaned with wax and grease remover before applying conversion coating to prevent rust. Technician B says that a plastic paint cup or paint cup liner should be used to prevent acid etch primer from harming a steel paint cup. Who is correct?

A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B

Trades & Technology

One of the factors that determine the voltage amplitude of a Hall-effect device is its physical size.

Answer the following statement true (T) or false (F)

Trades & Technology