The current relay is wired with the:
A) Relay coil in parallel with the start winding and the contacts wired in series with the run winding.
B) Relay coil in parallel with the run winding and the contacts wired in series with the start winding.
C) Relay coil in series with the run winding and the contacts wired in series with the start winding.
D) Relay coil in series with the start winding and the contacts wired in series with the run winding.
C
You might also like to view...
While having a discussion, Technician A says that a glazed belt must be replaced because it will not grip the pulley tightly. Technician B says that if tension on a glazed belt is adjusted at specification, there is no need to replace it. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Which of the following is not a component of a tap set?
A. die tap B. bottoming tap C. taper tap D. plug tap E. none of the above
What effect do noncondensable gases have on a refrigeration system?
A) They increase evaporator pressure and decrease compression ratio. B) They create bubbles in the liquid refrigerant stream leaving the compressor. C) They increase condenser pressure and compression ratio. D) They decrease the compression ratio and condenser pressure.
Table 4.3, which follows, shows anthropometric measured data in mm of U.S. adults (19 to 60 years of age).
As a designer you are requested to arrange sitting in an auditorium such that most individuals will have an unobstructed view of the speaker screen. To do so you will need to :
a. Determine the body dimensions that are critical in the design:
i. Erect sitting height
ii. The line of vision of people sitting
b. Select a design principle and the percentage of the population you plan to accommodate.
c. Determine the minimum to raise based on your design principle.
What will be an ideal response?