How would you rate the general machinability of a very hard metal?

A) Low
B) No rating because hardness has no effect on machinability
C) Medium
D) High


A

Trades & Technology

You might also like to view...

In the accompanying figure, what is the measure of angle 2?

A. 38o B. 63o14' C. 78o46' D. 97o

Trades & Technology

What are the only byproducts left after ideal combustion in the internal combustion gasoline engine?

What will be an ideal response?

Trades & Technology

A basic frequency to voltage converter

A) utilizes an integrator B) has a comparator in the circuit C) uses a one-shot D) all of the above

Trades & Technology

What is the minimum width of support straps used to hang flexible ducts?

a. 1/4 inch b. 1 inch c. 1-1/2 inches d. 2 inches

Trades & Technology