When calculating appliance load in a one-family dwelling, ____ should be used.
A. demand factors
B. compliance ratings
C. BTUs
D. nameplate ratings
Answer: D
You might also like to view...
The items that are included in PONC as part of the formula for "Cost of Quality" include which items listed below?
A) Loss of sales B) Additional parts cost C) Cost to pick up vehicle and/or additional parts D) All of the above E) All of the above except A
When the Hydro-Boost is in the release phase ________
A) The fluid port to the power chamber is closed B) The vent port is opened C) Both A and B D) Neither A nor B
What is the possible consequence of cutting through a bonded roof to install a vent pipe?
A) Cutting through bonded roofing is safe because the roof is insured B) The vent will not vent correctly when passing through a bonded roof C) The HVACR contractor could ultimately be liable for any water damage resulting from leaks D) An electrical short between the vent pipe and the bond on the roof
In the above figure, if the wiper arm of the high-speed rheostat is positioned at the middle of the resistor body and the low-speed rheostat is adjusted fully downward, which voltage range is most likely developed at the wiper arm of R2?
A. 0 to +15V B. 0 to +12V C. +3 to +15V