Section 404.2(C) requires a grounded conductor be installed at the switch location unless there is a way to install a grounded conductor in the future if one is needed. This means that a three-wire cable with a white grounded conductor instead of a two-wire cable with a reidentified white wire would need to be installed between the lighting outlet and the switch box location. List the situations when this is not required.

What will be an ideal response?


1. The conductors enter the switch box through a raceway and a new grounded conductor could be installed in the raceway at a later date.
2. The switch box is accessible for the installation of another cable with a grounded conductor without removing any wall or ceiling finish materials like sheetrock.
3. The switch does not serve a habitable room, bathroom, hallway, or stairway. Examples where this rule does not apply are garages or unfinished basements.
4. Multiple switch locations with three-way and four-way switches are used to control the same lighting load and the entire floor area of the room is visible from all of the switch locations. If this is the case only a grounded wire is required at only one switching location.
5. The lighting load is controlled by automatic means like an energy management system.
6. The switch controls a receptacle load.

Trades & Technology

You might also like to view...

Which part of an EES supplies power to major electrical equipment that is not directly related to patient care?

a. Critical branch b. Emergency branch c. Equipment branch d. Life safety branch

Trades & Technology

How is the common name of plants derived?

What will be an ideal response?

Trades & Technology

If one input of a 2-input AND gate is shorted to logic 0, the output will

A) equal the inverse of the logic level at the remaining input. B) always be 0. C) equal the logic level at the remaining input. D) always be 1.

Trades & Technology

Most vapor charging is done with the compressor operating while charging is taking place; however, liquid charging:

A) Is always done with the compressor on. B) Can be done either with the system off or operating. C) Is typically done on smaller systems with the system on. D) Is always done with the compressor off.

Trades & Technology