Answer the following statement(s) true (T) or false (F)

1. An engineering drawing is an important document in an organization because it affects the success of both the product and the organization.
2. The function of a product determines the amount of variation permitted for each dimension.
3. Engineering drawings cannot be used as evidence in product litigation cases.
4. The ISO standards are created in the U.S., but are used globally.
5. Dimensioning and tolerancing standards are used on most engineering drawings around the world.


1. T
2. T
3. F
4. F
5. T

Trades & Technology

You might also like to view...

When pulling cable with a capstan, what is the maximum pulling speed that should utilized?

a. 10 feet per minute b. 20 feet per minute c. 40 feet per minute d. 75 feet per minute

Trades & Technology

Which of the following is a key steering component?

a. Gear box b. Torque rod c. Bearing plate d. Leaf spring

Trades & Technology

With which signal pattern is the RMS reading the same as the average reading?

A) Square wave B) Nonsymmetric C) Sine wave D) None of these

Trades & Technology

Technician A says that a two-wire variable resistor is called a rheostat. Technician B says that a three-wire variable resistor is called a potentiometer. Which technician is correct?

A) Technician A B) Technician B C) Both technicians D) Neither technician

Trades & Technology