The weight of weld metal required to fill the groove or make the fillet weld is determined by ____.
A. multiplying the weld volume times the density of the metal
B. dividing the weld volume by the density of the metal
C. adding the weld volume and the density of the metal
D. subtracting the weld volume from the density of the metal
Answer: A
You might also like to view...
Wood I-joists covered with plywood can be used for site-built _____.
a. column forms b. wide pan forms c. dome-pan forms d. beam forms
Describe the differences between a diversion ditch and a diversion berm
What will be an ideal response?
The IEEE/ANSI symbol for a decoder has the internal designation BCD/DEC, how many pins; including Vcc and ground, would this IC have?
A) 20 B) 16 C) 14 D) 18
Technician A says the roof of a vehicle that is struck hard in the center of the side will lean toward the side of the vehicle that was struck. Technician B says one should walk around the vehicle to help create a visual replay of the collision. Who is correct?
A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B