Parting tools can jam in the cut and break as a result of:
A) Cutting speed that is too high B) The tool is set above center
C) Feed that is too light D) Lack of cutting oil or too heavy feed
D
Trades & Technology
You might also like to view...
Explain what an addendum is and when it is used.
What will be an ideal response?
Trades & Technology
Fully describe the weld, if one is required, at joint C. 1?4??
Refer to Drawing Number 09022601 REV D.
Trades & Technology
Where is the suction line temperature read when adjusting a TEV?
A) As close as possible to the TEV bulb B) As close as possible to the discharge service valve C) At the inlet of the compressor D) At the inlet of the evaporator
Trades & Technology
Define pitch as related to thread terminology.
What will be an ideal response?
Trades & Technology