According to the International System of Units (SI), linear unit commonly used on drawings is the inch.
Answer the following statement true (T) or false (F)
False
You might also like to view...
Components such as float switches and pressure switches will generally be located on tanks.
Answer the following statement true (T) or false (F)
Which of the following operational hazards can cause damage to the equipment from unfiltered or undried process fluid? (Select all that apply.)
a. Fouling b. Channeling c. Breakthrough d. Equipment leakage
The International Building Code (IBC) specifies that the height of a riser shall not exceed 7 3/4 inches and that the width of a tread not be less than ____ inches.
a.10 b.12 c.14 d.16
Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says A TP sensor can be tested using a DMM, DSO, or scan tool. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician