A large lead angle on the cutting tool:
A) Makes a chip thinner than the feed per tooth B) Permits the cutting of square shoulder chips
C) Make the chip thicker than the feed per tooth D) All of the above
A
You might also like to view...
When removing a nut from a long stud, the MOST-Likely tool used to provide clearance is the:
A. spark plug. B. screwdriver. C. deep socket. D. wrench.
PROBLEM 3.61 The mass moment of inertia of a gear is to be determined experimentally by using a torsional pendulum consisting of a 6-ft steel wire. Knowing that G ? 11.2 ? 106 psi, determine the diameter of the wire for which the torsional spring constant will be 4.27 lb ? ft/rad.
Where is the preferred work point location for welded bracing elements?
What will be an ideal response?
Technician A says that the most commonly used combustion chamber types include hemispherical, and wedge. Technician B says that coolant and lubricating openings and passages are located throughout most cylinder heads. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B