The asynchronous inputs are normally labeled ________ and ________, and are normally active ________ inputs
A) START, STOP, low B) PRE, CLR, low
C) ON, OFF, high D) SET, RESET, high
B
Trades & Technology
You might also like to view...
?The breaking of chemical bonds by ____ is the cause for degradation of plastics.
A. ?pyrolysis B. ?oxidation C. ?hydrolysis D. ?destabilization
Trades & Technology
Front and rear drive shaft U-joint working angles should be within ________ degrees of each other.
A) 3.0 B) 4.0 C) 1.0 D) 0.5
Trades & Technology
The interval from three standard deviations below the mean to three standard deviations above the mean contains approximately ______% of the measurements.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
Pressure is the force exerted against an opposing fluid or thrust distributed over a surface.