List 10 safety rules to be followed when using power tools
What will be an ideal response?
(1) Plug into an outlet protected by a ground-fault interrupter when possible and at all times when wet
conditions exist. (2) If the tool housing is metal, be sure to use a three-wire grounded power source. (3)
Be certain the power cord, switch, and all electrical parts are in good condition. (4) Be certain that
blades, bits, and other cutting units are clean and sharp. (5) Support work carefully to avoid any
tendency for it to bend, buckle, or bind when power tools are used. (6) Keep power tools clean and
free of dirt. (7) Keep vent holes free of dirt to permit ventilation and cooling of the motor. (8) Wear
complete body protection. (9) Exercise care to avoid accidental electrocution caused by working in wet
areas or by cutting power cords. (10) Do not force power tools to cut, drill, or otherwise work faster
than designed to work. (11) Hold every power tool firmly and in control at all times. (12) In school,
always obtain the instructor's permission before using a power tool. (13) If there is any question about
the condition of a power tool, check with the instructor before proceeding. (14) Announce to others
around you when you are ready to start a power tool. (15) Lay the power tool down safely so that it
will not damage cutting parts or injure others. (16) Report any faulty condition of the power tool and
its cutting parts to the instructor as soon as it is noticed.
You might also like to view...
What is the term that refers to a temperature spread in a water heater tank that results in the first water out of the tank being too hot to be safe?
a. stacking b. overheating c. convection d. conduction
Concrete shell roofs are not commonly used because
A) they require a relatively large amount of concrete per square foot of floor area. B) they require prestressing, which substantially raises their cost. C) they require a relatively large amount of steel reinforcement per square foot. D) all of the above. E) none of the above.
The water temperature leaving a water cooled condenser is 100°. What does that indicate the condensing temperature should be?
a. 90° b. 110° c. 130° d. 135°
What framing materials are used in commercial greenhouses?
What will be an ideal response?