Technician A says that the best way to warm power steering fluid to operating temperature is to start the engine and then cycle the steering from full lock to full lock until the temperature exceeds 140 degrees. Technician A says that the maximum reading on a power steering flow meter will be observed when the gate valve is almost fully closed. Who is correct?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A nor B
Answer: A
You might also like to view...
The recommended R-value to obtain a moderate comfort standard for a ceiling is _____.
a. R-19 b. R-11 c. R-38 d. R-26
An important step in complaint resolution is ________.
A) Negotiating the settlement B) Only fix the car C) Always do what the customer wants D) None of the above
?While discussing input and final drive endplay checks: Technician A says the purpose of these settings is to provide long gear life. Technician B says these settings are to eliminate engagement "clunk." Who is correct?
A. ?A only B. ?B only C. ?Both A and B D. ?Neither A nor B
When a cutting job is completed and the oxyfuel equipment is no longer needed, the first step in shutting
down the oxyfuel cutting equipment is to _____. a. close the fuel gas cylinder valve b. back out the fuel gas and oxygen regulator adjusting screws c. open the fuel gas torch valve d. open the oxygen torch valve